Sabiana Elegant Ecm Axial Fans
ELEGANT ECM AXIAL FANS
ELEGANT ECM AXIAL FANSB
The Elegant ECM Sabiana air conditioners allow, at very economical cost, to heat and cool small and medium size environments, like shops, show rooms, workshops, supermarkets.
The range is made up of 12 models: 8 RE-ECM models, for heating only, and 4 PE-ECM models, for heating and cooling. All models are for ceiling installation and for hot/chilled water supply.
The Elegant series uses an innovative brushless synchronous permanent magnet electric motor controlled by an inverter card that is directly installed on the unit. The heat outputs range from 6 to 26 kW and the cooling capacities from 4 to 10 kW.
FEATURES
ELECTRONIC MOTOR
Three phase permanent magnet brushless electronic motor. The inverter board that controls the motor operation is powered by 230 Volt, single-phase and it generates a frequency modulated wave form power supply. The electric power supply required for the machine is therefore single-phase with voltage of 230-240V and frequency of 50-60Hz.
CASING
Made of steel on both top and bottom sections and it is then finished with an epoxy-polyester powder coating dried at 180°, in white RAL 9016. The lower casing is also the condensate collection tray. The components are assembled with screws and so it is possible to quickly dismantle it for inspection when needed.
OUTLET GRIDS
The discharge of the air is obtained through 4 grids on the 4 lateral sides. They are comprised by a frame in which the louvres are individually adjustable. It is very easy to take off these grids, allowing for easy maintenance of the coil and of the condensate tray.
HELICOIDAL FAN
The fan is made with statically and dynamically balanced plastic blades. Its rational high-capacity profile provides the maximum air volume with the minimum energy consumption. The fan hub is secured onto the motor shaft and it is protected by a safety guard.
COIL
The coil is constructed of copper tubes with aluminium fins and steel headers. The supply and return connections have a female threading, 1” diameter, and they allow the connection either vertically from above or horizontally from a side. The coil is supplied in two versions: with 1 row and with 2 rows. The coil is not suitable for use in corrosive atmosphere or in environments where aluminium may be subject to corrosion.
CONDENSATE MICRO-PUMP
The PE–ECM model for cooling is always supplied with an integral micro- pump (discharge head 3m, water flow 6l/h). The pump is installed in the condensate collected tray. This pump controls the level of the condensate collected in the tray and drain it when necessary.
INFORMATION
PRODUCT TYPE
Axial Fans
PRODUCTION
Made In Italy
BRAND
Sabiana
USE
Ceiling Installation
HEAT OUTPUTS RANGE
6 to 26 kW
COOLING CAPACITIES
4 to 10 kW.
DATA
The intake of the air is from the bottom side of the unit and the air supply is from the 4 lateral grids which have individually controllable louvres for the best distribution of the air.
CONTROLS
- The condensate drain is made through an electronically controlled micro-pump, supplied on every standard PE–ECM model.
- Different remote controls of the air flow and of the room temperature are available and it is possible to control up to 10 units with only one remote control.
- All the Elegant ECM units can be supplied with a wide range of controls
- Using The Modbus Rtu - Rs 485 Communication Protocol.
INSTALLED
The Elegant ECM series uses an innovative brushless synchronous permanent magnet electric motor controlled by an inverter card that is directly installed on the unit.
