Galvamet, S.r.l. Unipersonale

Galvamet Vapore Hood

VAPORE HOOD

Galvamet  Vapore Hood

VAPORE HOOD

VAPORE heats all the lower surfaces immediately after being turned on, bringing them to a certain temperature that prevents condensation from forming. The sucked air, still full of humidity, then passes through cold surfaces inside the hood where it releases the water contained in it, and is then collected in an internal tray.

INFORMATION

TANK

In this tank there are electronic sensors that continuously monitor the water level, stopping the hood motor as soon as the level reaches the maximum. The command LEDs flash to signal this condition. Emptying the drip tray is very simple and fast, and is performed by pressing a lever and placing a container under the drain valve. Only after having emptied the tray will the hood start working again.

BRAND 

Galvamet

PRODUCT TYPE 

 Hood

DIMENSION

60 – 80 cm

REDUCTION

150-125mm

FINISHING

Inox

Galvamet  Vapore Hood

LIGHTS

LED 2×1,2W – 3000K

TOTAL ABSORPTION

407.4 W

PRODUCTION

Made in Italy

SOUND POWER

69 dB(A)

VERSION

Duct out

ENERGY CLASS

A

ACCESSORIES

-One-way valve cod. 0051H02000
-Long Life filtering kit : cod. 005LV03006

TECHNICAL DRAWINGS

Galvamet  Vapore Hood

MAX AIRFLOW

631 m3/h

CONTROLS

Electronic Soft Touch 4S

INSTALLATION

Built-In

MINIMUM DISTANCE FROM GAS HOB

58 cm

DETAIL

LIGHT INDICATOR FOR THE REGENERATION OF LONG LIFE FILTERS

The Long Life odor filter captures all the smells present in the cooking fumes, guaranteeing pure air in your kitchen. It does not need to be replaced as frequently as a normal activated carbon filter, it can be regenerated every 3-4 months, and in any case according to the frequency of use of the hood, with a usual washing in the dishwasher at about 70 ° C without any type of detergent, followed by drying in the oven for 30 minutes at 70 ° C. To keep its efficiency high, it is recommended to replace the Long Life filter after 6/8 regeneration cycles.

PERIMETER EXTRACTION

This consists of a mechanical system that literally forces, pushes, the cooking fumes extracted along a slit that runs along the perimeter of the cooker hood. This system increases extraction performance whilst reducing cooker hood noise emission. Design and appearance are also improved as the grease filters are no longer visible.

LIGHT INDICATOR FOR GREASE FILTER MAINTENANCE

The cooker hood automatically informs you when the metal grease filter designed for trapping grease in the air requires cleaning. It is of utmost importance to clean these filters to ensure cooker hood components are protected and to prevent bad odours caused by a build-up of grease.

ADJUSTABLE AND DELAYED SELF-SWITCHING OFF

This function allows you to programme delayed cooker hood shutdown which, in the shortest time possible, provides the right level of air purity in your kitchen.

Galvamet, S.r.l. Unipersonale
T +39 049 5942144 F +39 049 5940061
Galvamet, S.r.l. Unipersonale
Viale dell'Industria, 10, 35014 Fontaniva PD, Italy